service car star jump start cars service

Follow this steps every time you need to use emergency or service car battery that is dead while you are  driving always keep service car jump start cables a jump start battery cables is the next option to restart you car

A car jumping is always the next option when the battery is empty. As with modern cars, the manual and stick to the safest and recommended by the manufacturer's manual methods. There are many methods that you can use, but this article focuses on the safest procedures that are available. Otherwise, if done properly, life can be easily affected and damage to components can result. Here are the steps.

Step 1: Prepare the activities carefully

Identify a car powered by a battery. Take yourself near the car dead without touching it. The distance between the two cars can even be 12 to 20 centimeters. Then prepare two bridges insulated jump start cables and make sure that the length of the cable pair is suitable for the task.


Step 2: Connect the red bridge


Standard cable red bridge is positive. Open the crocodile clips and connect one end of the cable to the positive pole of the battery. Then the free end and connect with the positive terminal of the battery module. The battery is less safe to start, since it has a relatively low voltage.


Step 3: Close the black jumper


This time, starting with the black connection cable connection with the negative terminal of the battery during operation. The free end can then be connected to the chassis of the vehicle or to the death of exposed metal parts. Some cars come with a default for certain jump insurance points. This way you can safely connect. Never connect the other end of the black wire to the negative pole of the battery. This can be fatal and harmful to your system.


Step 4: Check the connections and settings


Before proceeding, check all step by step connections. Make sure the red wire runs between the positive terminal. Physically checks the safety of crocodile clamps on each terminal. Observe the negative connection cables and make sure that it is working from the negative pole of the exposed metal part of operation of the battery empty. Finally, a visual inspection and make sure that both vehicles do not touch.


Step 5: Start the live car


Enter the live car and start the engine. Some may require the ignition key to be inserted and rotated, while others may have a key arrangement for the same purpose. Let the car run for at least 60 seconds. If you want, you can even speed up your speed to speed up the process.


Step 6: Disconnect the connection cables


Disconnect the black battery cable. Before and pull the car loaded. They also separate the red bridge in the same pattern.


Step 7: Start the car loaded


Finally, the death was originally the car one. Start the engine. It should definitely work. If it fails, it does not have enough load. In this case, repeat the steps two to six before you start the engine.


And if after the failure of more than two attempts to collect?


If you have enough battery charged and the engine does not work, then there is another problem. First, your assumption is wrong. The battery is not charging. The failure of the load could be a result of using a battery that has survived the service life. Check the date of the battery purchased. If more, then four or five years is a strong possibility that should be replaced.


However, if the battery is good, the charging system might be defective. This could be the result of an alternating current generator, a faulty section or the connection to the load circuit will be. To confirm the failure of the charging system while the engine is running, and check your voltmeter readings. The voltage should further increase to 14 volts when the engine is running. When revving, the value of the output voltage should also react positively

1 Response

  1. Ηello, after reading tһis remarkаble paragraph i am too happy to share my familiarity here with ϲolleagueѕ.

Leave a comment